Specification Data

Quick 6 Series Channel Sections

Quick-Trench channels are 1 meter (39.4 in) polypropylene sections with uniform exterior and 0.5% sloped or neutral interior full radius bottom for efficient liquid drainage. Channels mate to adjacent sections via integral ears, clips, and 25 mm (1 in) overlapping tongue. Each channel contains 4 receptacles for fixation to #3 rebar via wire or cable tie. Up to 15 meter (49.2 ft) sloped drainage run is possible to a single end point. Up to 30 meter (98.4 ft) sloped drainage run is possible to a center collection point. Neutral channels are available to extend run lengths or where level trench drain is desired. Channels have staggered semi-circular cutouts on each side at bottom to enable concrete flow under legs. Drainage options include bottom outlet, end outlet, or catch basin. Bottom and end outlet fittings in PVC are sized to accept 3 in or 4 in pipe. Bottom and end outlet fittings are available in PP where chemical resistance is needed. End fittings are universal fit and field trimmed to appropriate height. Grating options include ductile iron, galvanized, stainless steel, and plastic with lock down feature to secure grate to channel. Grate load ratings are available in Classes A-E and may be specified ADA compliant. Refer to adjacent Trench Channel Table for upstream (U) and downstream (D) depths from top of channel.

Q6-1000 Channels

Quick 6 Series End Caps and Outlets

Starting Cap
Used at upstream end of channel. Field trim to desired height. Available in PP if chemical resistance is needed.

Q6-SC-PP

Outlet Cap
Used at downstream end of channel. Field trim to desired height. Accepts 3” or 4” PVC pipe. Furnished with outlet blocked off if BPO is used at bottom of trench. Field drill with hole saw if end outlet drain is used. Available in PP if chemical resistance is needed.

Q6-OC-PP
Q6-OC-PVC

Bottom Outlet
May be installed at any position on bottom of channel for bottom drain option. Accepts 3” or 4” PVC pipe. Field drill through channel bottom with hole saw if bottom outlet is used. Available in PP if chemical resistance is needed.

Q6-BO-PVC
Q6-BO-PP

Quick Clip
Used as a clip to join channel sections to other channel sections, channel sections to end fittings, and channel sections to catch basin. Also used as a spacer to maintain spread at top of channel during concrete pour

Q6-CS-PP

Finish Cap
Attaches to top of SEC or OEC to bring end fitting height up to grate level.

Q6-FC-PP

Catch Basin
Used where deep collection point is desired at end of trench. Mates to any channel section, also accepts OEC or BPO fittings for drainage outlet options. Strainer basket available for debris collection. Length is ½ meter.